How To Clean The F6 Medium Efficiency Bag Filter?

F6 Medium Efficiency Bag Filter

Different from disposable filter consumables, the F6 Medium Efficiency Bag Filter can be cleaned and reused properly. Appropriate cleaning measures extend service life and sustain stable filtration and ventilation performance, whereas improper operations may tear filter media and ruin filtering capability. The core cleaning principle is to prioritise dry cleaning and treat water washing with caution. All operations should be gentle and focus on proper preservation, and no specialised gear or expertise is required.
For filters with light dust accumulation, routine dry cleaning is the preferred solution. Power off relevant equipment before removing the filter from air ducts. Shake filter bags softly to dislodge loose surface dust, lint and particulate matter. Do not jerk or pull filter bags hard, otherwise seams may split and bags may deform. Next, use a soft‑bristle brush to sweep dust along the texture of filter media. Pay extra attention to creases and corners where dust tends to collect. A household vacuum cleaner running at low suction can also remove surface dust by moving slowly over filter surfaces. Never apply maximum suction, as intense suction may destroy fibre structures.

For moderately soiled filters with slight dark discoloration, low‑pressure reverse blowing works well. Use an ordinary blower or low‑pressure air pump, keep a distance of more than 30 centimetres and blow air from the air‑outlet side. Reverse airflow clears blocked pores and expels embedded dust. Move the air source constantly instead of aiming at one single area for long. Local high temperature or intense airflow would trigger ageing and physical damage. This method restores air permeability and filtration efficiency and prevails in commercial and industrial‑site deep cleaning workflows.
Many users wonder whether water washing is permissible. In general, frequent water washing is not recommended. Only filters contaminated purely by dust without oil stains may undergo occasional mild water rinsing. Use room‑temperature clean water; hot water, soap solutions, detergents and disinfectants are prohibited. Chemical agents corrode fibres and impair filtering properties. Apply light rinsing only. Do not rub, wring or soak filter units, which would deform bags and make fibres shed. Lay cleaned filters flat in shaded ventilated areas for natural drying. Direct sunlight, high‑temperature baking and tumble‑drying must be avoided, because heat makes filter media shrink, age and turn brittle, leading to complete failure.
Inspection after cleaning matters greatly. Confirm that dried filters are intact, undamaged, undeformed and pore‑unobstructed prior to reinstallation. Adjust cleaning frequency according to surroundings. In typical indoor environments, perform cleaning every one to two months. For heavily dusty workshops, carry out cleaning every two to three weeks. Once dust solidifies, removal becomes extremely difficult. If filters suffer hardened dust cake, severe discoloration, obvious performance decline after cleaning or physical rupture, replacement is necessary rather than repeated cleaning. Standard maintenance maximises reusability and cuts long‑term operating expenditure for ventilation systems.

You Might Also Like

Send Inquiry