What should be noted for storing the Primary Bag Filter?
The Primary Bag Filter mainly consists of polyester chemical‑fiber filter media and supporting frames. Its constituent materials are sensitive to humidity, temperature and placement modes within storage environments. Proper standardized storage can well preserve its original filtering performance, fluffiness and structural stability and prevent mildew, deformation, aging and physical damage prior to commissioning. It greatly extends inventory‑storage cycles and avoids consumable waste. Accordingly, standardized storage is required for manufacturer stockpiling, merchant inventory holdings and end‑user spare‑part reserves. Humidity control constitutes the most critical storage consideration. Chemical‑fiber filter media is hygroscopic. When kept in humid, confined and poorly‑ventilated conditions for extended periods, it rapidly absorbs moisture from ambient air, which triggers softening and fiber adhesion. Unpleasant mildew odors will develop, and mold plus bacteria will proliferate, permanently damaging the fluffy structure of the filter media. All products must therefore be stored in dry, well‑ventilated indoor warehouses, kept far from water‑pooled floors and moisture‑seeping walls. Ventilation or dehumidification equipment shall be deployed during rainy seasons and damp‑return periods to avoid damp‑confined conditions. Outdoor storage or stacking is absolutely forbidden.
Next comes temperature and ambient‑condition protection. The storage environment shall remain cool at ambient temperature and free from extreme‑temperature influences. Prolonged direct sunlight triggers oxidative aging of chemical‑fiber filter media, rendering it brittle, hard‑textured and faded with reduced toughness and ventilation performance. Damage or poor ventilation may easily occur after subsequent installation. At the same time, keep stock away from heat‑generating equipment such as boilers, air heaters and hot‑air pipelines. High‑temperature baking will cause shrinkage, deformation and collapse of filter media and directly render the product unusable. The storage area must stay neat and clean. Oil‑stained materials, chemical raw materials, corrosive gases and dust‑laden sundries shall not be stacked on‑site. This prevents filter media from pre‑adsorbing oil stains and suffering premature dust‑clogging and pre‑mature failure. Bulk‑stocked products may be wrapped with dust‑proof films to isolate external impurities.
Finally, pay attention to placement modes and inventory maintenance. Possessing a fluffy, soft three‑dimensional bag‑type structure, the filter is susceptible to compression‑caused deformation. Store units flat with layered lightweight stacking and strictly control stacking height. Heavy‑weight compression, violent squeezing and folding‑twisting of bag bodies are prohibited. Otherwise, fiber compaction and bag collapse will take place, permanently erasing dust‑holding space and ventilation performance. Small‑volume spare products may be hung to maximally preserve structural form. Furthermore, monthly spot‑checks shall be performed for long‑term inventory products to identify dampness, mildew, deformation and rodent‑insect gnawing; adjust storage environments in a timely manner. Implement warehouse insect‑proof and rodent‑proof measures to prevent filter‑media gnawing damage. By complying with the above‑mentioned storage specifications, products can remain brand‑new for long periods and go into normal service directly after unpacking without any performance loss.







