What precautions should be taken when using Diamond Mesh Primary Filters?
The service life and filtration efficiency of Diamond Mesh Primary Filters depend heavily on proper operation and routine maintenance. Although the metal diamond‑mesh construction offers sound durability, strict requirements apply to installation, operation, maintenance and environmental adaptation. Standardized practices prolong equipment service life, guarantee filtration performance and avert mechanical faults and potential safety hazards. Major precautions fall into five categories: installation, operation, maintenance, operating environment and storage.
For installation, complete flat and standardized assembly is essential. The filter shall closely fit equipment frames and ventilation ducts with intact sealing strips to eliminate gaps, offset and loose connections. Poor sealing allows unfiltered air to bypass the filter, resulting in filtration failure and heavy contamination of downstream equipment. Inspect filters before installation for deformation, damage, mesh detachment or rust. Do not pull or bend the mesh during fitting, as distorted diamond‑mesh geometry will impair airflow and filtration accuracy. After installation, verify unobstructed air passage without blockages.
During operation, adhere strictly to design‑specified air pressure and wind speed parameters. Over‑pressure or over‑speed airflow will strike the diamond mesh, causing mesh stretching, wire fracture or border detachment. Structural damage will allow contaminant penetration. Avoid prolonged full‑load continuous operation. Regulate air volume according to system design to prevent accelerated dust accumulation and ageing under sustained high‑load conditions. Protect the mesh from blows and scratches by hard foreign bodies.
Routine cleaning constitutes core maintenance. Being washable and reusable, the filter requires cleaning cycles matched with site dust concentration. For ordinary commercial environments, cleaning every one to two months is recommended; for dusty industrial settings, shorten the interval to two‑to‑four weeks. Use low‑pressure water flushing combined with soft‑brush scrubbing. Strong‑acid or strong‑alkaline detergents are prohibited to avoid corrosion of metal mesh and protective coatings. Thorough natural ventilation drying is mandatory before reinstallation. Never install wet filters, otherwise mildew, rust and indoor air contamination will occur. Replace filters promptly when irreversible deformation, rust, wire breakage or non‑removable heavy fouling appears.
Regarding environmental adaptability, continuous long‑term service under extreme conditions of high temperature, excessive humidity, strong acid‑base corrosion or heavy oil fume is not permitted. Sustained high temperature accelerates peeling of protective coatings. High humidity triggers metal rust and mould growth. Corrosive gas and heavy oil fume form stubborn deposits that cannot be cleaned and lead to premature scrapping. Do not deploy this filter blindly in sites with extremely high concentrations of flammable‑explosive dust to eliminate dust‑accumulation‑related risks. For long‑term decommissioning, fully clean and dry filters, then store them in dry, ventilated, corrosion‑free and dust‑free spaces. Avoid open‑air exposure to sunlight and rain which cause dampness and deformation.







